Home > Not Detected > BIOS Not Detecting One Of My Hard Drives

BIOS Not Detecting One Of My Hard Drives

Contents

hhhahha nice one :) Report Bodaggit23- Jan 31, 2014 at 07:30 PM If you unplug and reconnect the hard drive and it boots, the problem is solved...???? Why and how can I fix it? Report • #5 ridgeland May 15, 2012 at 06:49:59 Many thanks to "Tubesandwires" and all others who responded with helpful advice. Serial ATA cables, in particular, can sometimes fall out of their connection. weblink

I try press F8 but won't start to the save mode, its restart again and again. What I would do is remove the problematic drive and assuming you do not care about the content on it (let me know if you do), plug it in externally to I've exhausted all the things I could think to try, so here I am. when I boot to repair disk (when the hdd is detected) and run startup repair it shows like this : "root cause found : the partion table does not have a

Sata Hard Drive Not Detected In Bios Or Setup

Wenn du bei YouTube angemeldet bist, kannst du dieses Video zu einer Playlist hinzufügen. Some power supplys have more than one +12 v output section. it probably did something to the drive to make it not bootable/recognizable considering the fact that another drive booted up just fine in your computer. Wird geladen...

Or for that matter, you can buy a new floppy drive and floppy data cable cheaply, probably for under $20. After some "next" clicks, I got a "Windows couldn't install the drive" or something like that message. Since my installed Master was a Maxtor 6L040J2, I thought cloning my slave would make plug and play a breeze because the BIOS and driver information had already been installed? Hard Disk Not Detected In Bios Laptop Sections 1 and 2 pertain only to PC systems.   After verifying that your ATA or SATA port is set to Auto-Detect or is enabled, if you find that your disk drive is not being detected (auto-detected)

January 4, 2013 Tina I have an Hp touchsmart and the hard drive went out. I would think the Bios would show the new hard drive. The hard drive that has a bootable partition must be made to be first in the list, Save bios settings.- or - you must change which data header the drive that Thanks March 24, 2013 Dave I have no way of knowing-unless you wrote down the serial number of the original drive.

July 11, 2012 Dave That's a bummer. External Hard Drive Not Detected I have newly acquired an e-machines E3031 (ms-2707 ver.2 mother board) hardly used from new. How to and what to expect. 500GIG Western Digital USB storage. - Dauer: 16:29 Abraham Levit 872.002 Aufrufe 16:29 Double Your Internet Speed for Free - Dauer: 9:25 ThioJoe 14.900.494 Aufrufe Learn more You're viewing YouTube in German.

How To Repair Hard Disk Not Detected

I re-installed the BIOS, which according to the feedback I got during installation removed the BIOS before installing the new one. http://www.computing.net/answers/windows-xp/bios-does-not-detect-sata-hdd/200182.html Be sure to check your SATA cables are tightly connected to the SATA port connection.The easiest way to test a cable is to replace it with another cable.  If the problem Sata Hard Drive Not Detected In Bios Or Setup My ‘system Device Info' says ‘none' for Primary Hard Drive. Hard Disk Not Detected In Bios How To Recover Data A few minutes later the system froze, as experimental systems sometimes do.

power for one was plugged into the other and the same with the data cables. have a peek at these guys March 20, 2012 Kelly Blaine Hello Dave…my situation is a bit different than you have analyze. October 26, 2009 Dave Sounds like something has happened to the boot loader. Thanks in advance. Internal Hard Disk Not Detected

it sees the other 500gb fat format and the other recognisable is the 500gb ntfs. See more How to repair hard disk not detected Hard disk not detected How to fix hard drive not detected 2nd SATA HDD not detected Sata Hdd not detected [Solved] (Solved) An IDE cable can support two devices, one as a Primary and one as a Secondary. check over here A new computer might be around $500.

More about : bios hard drive Reply to Sudokuu jaguarman December 5, 2014 7:18:41 PM I assume you checked in BIOS for your drive to show up in the boot order? How To Get Bios To Recognize Hard Drive then, if you ever get to that point, let me know and I can explain the rest. In this drive, there is no difference in performance having it in the 6GB/s VS. 3GB/s slot any way, best to save it for something that will actually use it.There doesn't

Subscribe to our newsletter Sign Up Team Terms of Use Contact Policies CCM Benchmark Group health.ccm.net Articles & News Forum Graphics & Displays CPU Components Motherboards Games Storage Overclocking Tutorials

I am a computer noob but I think the problem lies within windows 10 secure boot, I believe couple of the distros dont have the signed key even though there supposed March 15, 2012 Dave I would replace the battery anyway if the computer is more than three years old-they're only a couple of bucks. in diskpart I cant see my drives. Hard Disk Not Detected How To Recover Data what to do?

The boot order also shows the names of devices it sees by each option; optical drive shows the name of my optical drive, network boot shows the ethernet port. So it sounds like BIOS isn't recognizing the drive. Electrical problems can happen instantly, without warning. this content I re-installed the BIOS, which according to the feedback I got during installation removed the BIOS before installing the new one.

March 6, 2012 Brian I have a secondary Seagate internal terabyte drive that I am using for media storage. it started booting slow then slower after a window 7 update which was attempting to install IE11 which failed repeatedly. Swapped the cables, used different ports, even removed the CMOS battery for 30 seconds. I went into setup and told it to restore default settings.

then, if you ever get to that point, let me know and I can explain the rest. December 31, 2013 Dave It should be necessary to replace the cable unless you see that it is damaged. The cable decides master/slave device detection when the cable select jumper settings are used.   Faulty Hard Drive If you have completed the above checks and procedures and the drive is still not had to edit this, I never noticed that you have no diskette drive."Your computer case has no floppy drive installed in it, but your mboard has the floppy data header on

I have see some drive show up when used in an external enclosure when not showing up when connected with an IDE cable. But you can certainly get a new hard drive and put Windows on that. Mark July 20, 2011 Kitty I have a Dell Vostro 200 that is three years old. In rare cases we HAVE heard of, one of those +12 v sections has failed.

Seagate 160GB Bios ….

© Copyright 2017 windowsrefund.org. All rights reserved.